Disassembly of the parts (Indoor unit)
Warning :
Disconnect the unit from power supply before making
any checks.
Be sure the power switch is set to "OFF".
1. To remove the Grille from the Chassis.
- Pull the grille bottom, the remove 2 securing screws.
- Lift the both lower parts of panel front.
- After pull down this panel a bit, separate connecting
wire with product.
(When seperating the connectors, Push the Rip on
connector tightly.)
2. To remove the Control Box.
- Before removing the control box, be sure to
disconnect the wires from PWB.
- Pull the cover control out from the control box
and disconnect other wires.
- Remove securing screws.
- Pull the control box out from the chassis carefully.
-34-
Panel Front
Connector
Step Motor Connectors
Sensor Connector
4Way/Fan Connector
Comp Connector
Motor
Power Connector
Connector
Power Connector
Comp Connector