Parts Ordering; Parts Kits - Emerson Fisher 3582 Instruction Manual

3582, 582i, and 3583
converter housing and the valve positioner case.
Attach the converter housing to the valve positioner
case with the screws (key 11) and tighten the
screws.
2. If the I/P module was removed from the 582i
converter, reinstall the I/P module in the converter
housing. Secure the I/P module with the two screws
(key 9).
3. If other valve positioner components are
removed, refer to the appropriate reassembly
procedures and assemble the valve positioner
completely.
4. Reconnect the supply tubing, output tubing, and
conduit to the valve positioner.
5. Reconnect the wiring to the terminal block. Do
not overtighten the terminal screws. Maximum
torque is 0.45 NSm (4 lbfSin.). Reconnect the
grounding wire to the housing ground screw (key 10)
and replace the cap (key 2).
To check the operation of the I/P
module, remove the pipe plug (key 12),
and connect a pressure gauge.
Provide a 1.4 bar (20 psig) supply
pressure to the converter. With a 4
milliampere input signal the pressure
output should read 0.16 to 0.24 bar (2.3
to 3.5 psig). With a 20 milliampere
input signal the pressure output
should read 0.96 to 1.07 bar (14.0 to
15.5 psig).
6. Plug the output connection and apply 2.4 bar (35
psig) to the supply pressure connection.
CAUTION
Do not apply a signal greater than 35
mA to the I/P module. Higher signal
values may damage the converter
module.
7. Apply a 20 milliampere DC current input signal to
the converter.
8. Check for leaks using a soap solution. Check any
components which were disassembled or
disconnected.
32
Note

Parts Ordering

A serial number is assigned to each valve positioner
or valve stem position transmitter and is stamped on
the nameplate. Always refer to this number when
corresponding with your Emerson Process
Management sales office regarding spare parts or
technical information. When ordering parts, also give
the eleven-digit part number shown in the following
parts list.
WARNING
Use only genuine Fisher replacement
parts. Components that are not
supplied by Emerson Process
Management should not, under any
circumstances, be used in any Fisher
instrument. Use of components not
supplied by Emerson Process
Management may void your warranty,
might adversely affect the
performance of the instrument, and
could cause personal injury or
property damage.
Neither Emerson, Emerson Process
Management, nor any of their affiliated
associates assumes responsibility for
the selection, use, or maintenance of
any product. Responsibility for the
selection, use and maintenance of any
product remains with the purchaser
and end user.

Parts Kits

Description
Repair kit for positioner/transmitter (not for 3582NS)
Kit contains keys 11, 16, 17, 33B, 34C, 73, and 104.
This kit also contains keys 18C, 18E, and 18F
for 3580 and 3581 positioners
For standard temperature applications
For high temperature applications
Repair kit w/nozzle and flapper for the 3582 Positioner
Kit contains keys 11, 16, 17, 18, 19B, 19E,
33B, 34C, 73, and 104.
For standard temperature applications,
not for 3582NS
For high temperature applications,
not for 3582NS
For 3582NS, contains EPDM parts
Instruction Manual
June 2010
Note
Part Number
R3580X00022
R3580X00032
R3582X00012
R3582X00022
R3582X00032