Reversing The Door - Dometic D50 Operating Manual

D15, D50
8.3

Reversing the door

You can also change the hinge of the door, so that it opens to the left rather than the
right.
Then fit the door handle on the other side, see chapter "Fitting the door handle on
the other side" on page 15.
D15 and D50
➤ Change the door as described in fig. 3, page 3 to fig. 7, page 4.
Fitting the door handle on the other side
➤ Fit the door handle on the other side as described in fig. 8, page 4 to fig. 9,
page 4.
8.4 Notes on the electrical connections
A
NOTICE!
Leave the appliance to stand upright for about 2 hours after transporting,
before you connect it to the power supply.
Otherwise this could cause faults in the cooling system.
Observe the following when connecting the appliance:
• Connect this appliance to a separate 15 A circuit.
• Have the receptacle and the circuit checked by a qualified electrician to ensure
that the socket is grounded correctly.
• Check that the voltage specification on the type plate is the same as that of the
power supply.
• If you are using an extension cord, it must be suitable for the values which
correspond to the device, see chapter "Technical data" on page 26.
• Do not use an extension cord or a multiple power socket that can be switched off
with just one switch.
• The cord must rest securely behind the appliance and not be allowed to lie or
hang unprotected.
EN
Setting up and connecting the appliance
15