Ice Cubes; Useful Suggestions; Defrosting, Cleaning And Maintenance; Changing The Lightbulb - Dometic miniCool MF 20-60 Operating Instructions Manual

GB
conditions of load and installation. If it is found
necessary to change the setting, the knob can be
turned to a higher number to give a lower temperature,
or a lower number to give a higher temperature. The
effect of any adjustment can be checked by means
of a thermometer when the refrigerator has reached
the new temperature after some hours.
Figure 4.

6. Ice cubes

Fill the ice tray up to 4/5 with drinking water, and
place the ice tray on the ice-tray shelf. Wipe off
any excess water to prevent the ice tray from
freezing to the surface.
To speed up the making of ice cubes, turn the
thermostat to position 5 for a short while. Remember
to turn the dial to its normal setting when the ice
cubes are frozen.
To remove the cubes from the ice tray, hold it under
running water. The ice cubes can now be taken out
easily
7. Useful suggestion
Do not overfill the appliance. Put warm foods and
drinks in the appliance only when they have cooled
down to room temperature. It is advisable to leave
some space between the products in the cabinet to
ensure efficient and even cooling. If the shelves
are packed too tightly there may be unacceptable
temperature variations.
8. Defrosting, cleaning and
maintenance
This frost-formation is kept back by the FUZZY
LOGIC system built into the appliance.
The first defrosting phase commences 39 hours
after the start and lasts for two hours.
After this, the device operates for 22 hours at a
time, followed by a defrosting period of 2 hours.
The frost will melt and the defrost water will run
through the drain tube from the drip channel into an
evaporating vessel located at the bottom rear of the
refrigerator. (Fig 5) The defrost water will evaporate
automatically into the circulating air and the vessel
will not need emptying.
To switch off the unit, turn the thermostat knob to
6
"0", disconnect the refrigerator from the electricity
supply and leave the cabinet door open. After
defrosting the cabinet interior should be wiped out
with a clean, damp cloth.
Figure 5.

9. Changing the lightbulb

If the lightbulb needs changing, pull out the plug and
proceed as follows:
Press the metal reflector to one side and draw the
lamp covering backwards. Replace the bulb and
push the covering back into place.
A new 10-watt bulb can be obtained at any service
shop.

10. Reversing the door hang

(Fig. 6)
Lay the appliance on its back. Remove the 8 screws
(1). Remove the door, together with the two hinges
(2), from the housing.
Remove the two cover caps (3) from the housing
and place them in the open hinge holes in the housing.
Place the bottom righthand hinge in the top left of
the door and the top righthand hinge in the bottom
left of the door and hang the door on its hinges in the
open cover cap holes in the housing. Secure the
hinges and cover caps with the 8 screws.
Check that the door closes easily and is sealed
properly.
Figure 6
(If available)