Diff Lock Control; Instrument Panel - Ransomes HIGHWAY 2130 Safety And Operation Manual

GB

6.13 DIFF LOCK CONTROL

The Diff lock (A) is operated by depressing the foot
switch. When the foot switch is released the Diff
Lock ceases to operate. The Diff Lock should only
be used in severe situations, and should never be
used on tarmac or whilst steering

6.14 INSTRUMENT PANEL

A. ENGINE PREHEAT INDICATOR LAMP
DIESEL ONLY
Colour green, on when the ignition switch is turned
clockwise to the pre-heat position. Once the lamp
goes out the engine can be started.
B. ENGINE TEMPERATURE GUAGE
Indicates current temparature of engine, whilst
running.
C. ENGINE OVERHEAT WARNING LAMP
Colour red, on when the engine temperature reaches
a preset level. If the lamp comes on and a warning
horn is sounded bring to machine to a stop,
disengage the cutting cylinders, apply the parking
brake and allow the engine to cool by running the
engine at half speed for two minutes before
stopping and investigating the cause.
D. CHARGING WARNING LAMP
Colour red, on when ignition is switched on and will go
out when the engine is started. If the light comes on
while the engine is running, the fan belt may be slipping
or broken or a fault in the electrical system is indicated
and should be investigated. STOP IMMEDIATELY.
E. ENGINE OIL PRESSURE WARNING LAMP
Colour red, on when the ignition is switched on, and will
go out once the engine has started. If the light comes on
while the engine is running - STOP IMMEDIATELY as
this indicates that the engine oil pressure is too low.
Check the level of oil in the sump and top up as
necessary. Check the oil pressure sender switch.
Continued operation may cause extensive damage to
the engine.
RANSOMES HIGHWAY 2130
SAFETY AND OPERATORS MANUAL
GB-15