Watchguard Firebox SOHO 6 Wireless User Manual page 84

connection, using Internet Protocol Security (IPSec), over an
unsecured network from your remote computer in order to
remotely manage your SOHO 6 Wireless.
For example, the MUVPN client is installed and configured on
your computer. You then establish a standard Internet connection
and activate the MUVPN client. The MUVPN client creates an
encrypted tunnel to your SOHO 6 Wireless. You can now access
the SOHO 6 Wireless configuration pages without compromising
security. Another way to remotely manage your SOHO 6 Wireless,
is using a Pocket PC. First you establish a standard Internet
connection using your Pocket PC, and then you can access the
SOHO 6 Wireless configuration page.
1 First, follow the steps above to configure System Security.
2 Enable the checkbox labeled Enable SOHO 6 Wireless
Wireless Remote Management.
3 Type the Virtual IP address which will be used by the remote
management computer when connecting to the SOHO 6
Wireless in the appropriate field.
4 In the Authentication Algorithm drop list, specify the
authentication: MD5-HMAC (128-bit authentication) or SHA1-
HMCA (160-bit authentication).
5 In the Encryption Algorithm drop list, specify the type of
encryption: DES-CBC or 3DES-CBC.
6 In the VPN Client Type drop list, specify the type of VPN
client: Mobile User (MUVPN) or Pocket PC.
Click Submit.
7
8 Next, you must install and configure the MUVPN client on
your remote computer.
For this information, see Chapter 10, "MUVPN Clients" on page 119.
9 Once you have installed and configured the MUVPN client,
establish an Internet connection through either Dial-Up
62 WatchGuard Firebox SOHO 6 Wireless