Mounting On A Wall Plate - Radio Shack ET-927 Owner's Manual

43-1097a.fm Page 7 Tuesday, August 31, 1999 10:01 PM
the back of the base, route the
adapter cord through the strain relief
slot and the hole on the bracket,
then push in the mounting bracket's
upper end to click the bracket into
place.
illus -- label strain relief
3. Plug one end of the supplied long
modular cord into the phone line
jack on the back of the base.
Illus
4. Plug the AC adapter into a standard
AC outlet.
Illus
5. Plug the modular cord's other end
into a modular phone line jack.
Illus
6. For the best reception, raise the
base's antenna to a vertical position.
Illus

Mounting on a Wall Plate

1. Push in the two tabs on the top of
the mounting bracket, then lift off the
entire bracket.
illus -- enlarge to fill space
2. Plug one end of the supplied short
modular cord into the phone line
jack on the back of the base, then
press the cord into the center
groove on the bottom of the base.
Illus
3. Insert the supplied AC adapter's
barrel plug into the
the back of the base. Then route the
cord through the strain relief slot
jack on
DC 9V
7