Connecting, Charging, And Replacing The Battery Pack - Radio Shack 2.4 GHz 2-Line Digital Spread Spectrum Cordless Phone with Call Waiting/Caller ID Owner's Manual

secure it. If you are using two phone
cords, plug the second cord into the sec-
ond phone jack.
6. Plug the adapter into a standard AC out-
let.
7. Press and lift out the handset holder, flip
it over, then snap it back into place.
8. Raise the base's antenna to a vertical
position.
Note: To mount the phone directly on a wall,
you need two screws of at least 1
(not supplied) with heads that fit into the key-
hole slots on the bottom of the base. Follow
the steps under "On a Wall Plate or Wall" on
Page 11, then apply these additional instruc-
tions for placement on a wall.
15
1. Drill two holes 3 /
16
apart. Then thread a screw into each
hole, letting the heads extend about
inch (3 mm) from the wall.
2. Plug one end of the supplied long modu-
lar cord into the
TEL LINE 1/2
back of the base.
To connect the phone to two one-line
jack, plug another cord (not supplied)
into the jack.
TEL LINE 2
3. Route the adapter cable and modular
cord(s) through the grooves on the
bracket.
4. Align the base's keyhole slots with the
mounting screws and slide the base
downward to secure it.
12
CONNECTING, CHARGING,
AND REPLACING THE
BATTERY PACK
The phone comes with a rechargeable nick-
el-cadmium battery pack installed in the
handset, but not connected. Before using
your phone, you must connect the battery
pack, then charge it for about 24 hours.
1. Press down then slide off the battery
2. Lift the battery pack out of the compart-
3
/ inch long
8
3. Plug the battery pack's connector into
inches (100 mm)
To charge the battery pack, simply place the
handset on the base, facing either up or
1
/
8
down. The base's CHARGE indicator lights.
Recharge the battery pack when
flashes on the handset's display.
jack on the
Important: Be sure the battery pack is prop-
erly connected before you try to charge it.
The CHARGE indicator lights when the
handset is on the base even if the battery
pack is not properly connected.
Notes:
Installation
compartment cover.
ment.
the socket in the compartment (the con-
nector fits only one way), replace the
battery pack, then replace the cover.
• When you first use the phone after
charging or recharging the battery pack,
the phone might not work and you might
hear an error tone when you press
or . If this happens, return the
1 LINE 2
handset to the base for about 5 sec-
onds. This resets the security access-
protection code.
• Using a pencil eraser, clean the charg-
ing contacts on the handset and the
base about once a month.
Bem 8Wjj[ho Bem 8Wjj[ho
Bem Bem 8Wjj[ho 8Wjj[ho
LINE