Receiving A Call - Radio Shack CT-600 Owner's Manual

17-1105.fm Page 19 Wednesday, July 21, 1999 11:06 AM
The vertical bar on the left of your phone's
display shows the strength of the cellular
signal your phone is receiving. The higher
the bar, the stronger the signal.
If the signal strength is low, try moving to
a different location. If you are using the
phone in a building, try moving closer to a
window.
If NO SERVICE appears, your phone is outside the
cellular service area. This means you cannot make
or receive calls until you move the phone back into
the cellular service area.

RECEIVING A CALL

When your phone receives an incoming call, it rings
(or vibrates if a vibrating battery is installed and vi-
brate is selected) and flashes CALL . To answer a
call, press any key except or . To stop the
PWR
END
phone from ringing without answering the call imme-
diately, press , then press when you
END SEND
are ready to answer the call.
Notes:
• After the first ring, if you subscribe to calling line
ID service through your cellular carrier (see
19