Table of Contents
Advertisement
Step
1.
Enter system view.
2.
Stop running patches.
Removing patches from the patch memory area
After being removed from the patch memory area, a patch is still retained in IDLE state in the storage
media. The system runs the way it did before it was installed with the patch.
To remove patches from the patch memory area:
Step
1.
Enter system view.
2.
Remove patches from the patch memory area.
Displaying and maintaining software upgrade
Task
Display information about system
software
Display information about the
patch package.
Display the patch information.
Software upgrade examples
Upgrading the entire system software
Network requirement
The current software version is soft-version1 for the switch in
image soft-version2.bin and the latest configuration file new-config.cfg are both saved in
flash:/aaa on the FTP server. The FTP server and the switch can reach each other.
Configure the switch to automatically upgrade the software version to soft-version2 and the
configuration file to new-config when the system is not busy.
Command
system-view
patch deactive [ patch-number ] slot slot-number
Command
system-view
patch delete [ patch-number ] slot slot-number
Command
display boot-loader [ slot
slot-number ] [ | { begin | exclude |
include } regular-expression ]
display patch [ | { begin | exclude |
include } regular-expression ]
display patch information [ | { begin |
exclude | include }
regular-expression ]
101
Remarks
Available in any view.
Available in any view.
Available in any view.
Figure
37. The latest system software
Advertisement
Table of Contents
