Advertisement
Quick Links
-
Photo of shift button installed in radio cab
Warranty
This product is fully factory tested and warranted against manufacturing defects for a period
of 1 year. As the circumstances under which this product is installed can not be controlled,
failure of the product due to installation problems can not be warranted. This includes
misuse, miswiring or operation under conditions beyond the design range of the product. No
guarantees are expressed or implied as to the suitability of the product for its intended use by
the purchaser.
For warranty or non-warranty replacement contact NCE Customer Service at 585-671-0370
between 9AM and 4PM Eastern US time or send the cab to:
NCE Warranty Center
82 East Main St.
Webster, NY 14580
::;pare parts for your cab may be ordered from the list below. $5 US will be added to
your order for US priority mail and packaging. Check or credit card will be
accepted.
Description
Price (US
Reolacement Potentiometer
Free (call)
Cab04/05 too with overlay
$8.00
Cab04/05 rear cover w/battery
$7.00
door
Cab04/05 screws (set of 4)
$2.00
Cab04/05 batterv holder
$1.50
Rubber kevoad for Cab04/05
$8.00
The terms Silent Running, Power Pro, Power Cab, ProCab, Switch-It, Snap It, the NCE logo with "The Power of
DCC" slogan and ProCab silhouette are trademarks of NCE Corporation. The distinctive shape of the ProCab and
Power Cab combined with Thumbwheel speed control and LCD is a trademark NCE Corporation.
Last revised: 28. July 2006
Address all parts orders to
$)
NCE Spare Parts
82 East Main St.
Webster, NY 14580
Page 8
Cab04p
Operations Manual
For
Cab version 3.1
Copyright 1994-2006 NCE Corporation
CAB-04p
Intermediate Cab
Last revised: 28. July 2006
Advertisement
Related Manuals for NCE CAB-04p
Summary of Contents for NCE CAB-04p
- Page 1 Rubber kevoad for Cab04/05 $8.00 The terms Silent Running, Power Pro, Power Cab, ProCab, Switch-It, Snap It, the NCE logo with "The Power of DCC" slogan and ProCab silhouette are trademarks of NCE Corporation. The distinctive shape of the ProCab and Power Cab combined with Thumbwheel speed control and LCD is a trademark NCE Corporation.
- Page 2 Setting the alternate button values: To the right is an illustration of the CAB04 Intermediate Cab. Following is a description of the various controls and indicators of the cab. Turn on the DCC system Unplug your cab from the Cab Bus STATUS LED Press and hold down the SELECT LOCO button while plugging in the cab.
- Page 3 If the E-Stop does not clear, press E-Stop until the status LED lights, then press ENTER again. NCE Power-Pro systems with software dated 21 December, 2004 and newer MACRO have an option to disable the Whole Layout Emergency Stop Macros are explained in detail in our system reference manual.
- Page 4 Table of values for OPTION button and "Shifted" buttons To change between REGULAR and YARD modes: Value Kev Name Value Kev Name l) Turn on the DCC system. Enter Program on Main Proaram Set Clock 2) Unplug your Cab04 from the cab bus Recall Use program track 3) Plug the cab back in while holding down the SELECT LOCO button.