Advertisement
Quick Links
AR10 Auto Reverser
Age
14+
Automatic Reverse Loop Controller
Features of the AR10:
Automatically controls polarity of DCC reverse loops
Provides short circuit protection for loop
Ready to run without any programming
Trip current adjustable 1 to 10 Amps
Easy hookup using screw terminals, no soldering
Solid state design provides silent, reliable operation
Status indication LED
Additional output for remote LED
Automatic or manual reset after short circuit shutdown
Adjustable short circuit response time
05240233
05240233
This book, schematics and artwork copyright 2020 NCE Corp., Webster, NY 14580
Warning: This product contains chemicals known to the state of California to cause
cancer, birth defects or other reproductive harm.
Advertisement
Related Manuals for NCE AR10
Summary of Contents for NCE AR10
- Page 1 Adjustable short circuit response time 05240233 05240233 This book, schematics and artwork copyright 2020 NCE Corp., Webster, NY 14580 Warning: This product contains chemicals known to the state of California to cause cancer, birth defects or other reproductive harm.
- Page 2 DCC systems. It will not work with any power system other than DCC. Mechanical Installation: The AR10 has 4 mounting holes that can be used to mount it to a convenient place on your layout. We recommend using #4 x 3/4” round orpan head screws. Do not over tighten the screws.
- Page 3 Once shut down the AR10 will try to restore power about once every 2 seconds. If there is still a short the AR10 will kill the power again, until the short is removed.
- Page 4 SHORT - This red LED is off under normal operating conditions. It will light steadily (and both green LEDs will be off) when the AR10 has removed power to the loop because it has detected a short circuit or overload condition. The AR10 will attempt to restore power to the track every 2 seconds[default setting] until the short circuit condition is corrected.
- Page 5 CV131 - Manual reset enable. If CV131 is set to 0 the manual reset is disabled and the AR10 will automatically try to turn on track power after a short circuit. If CV131 is set to 1 the AR10 will not automatically restore track power after a short circuit until a connection (usually with a pushbutton) is made between he RST terminals of the four position terminal strip.
- Page 6 The custom startup table provides a programmable method to pulse the track power on and off several times before the AR10 tests for over current. You can program the on and off times in increments of 1mS. Generally you will not use this table with most boosters but it may be useful with a booster that has weak startup capability.
- Page 7 Intentionally blank page **Last revised: 3 May 2020 Page 7 AR10...
- Page 8 Webster, New York 14580 The terms Silent Running, Powerhouse Pro, Power Pro, ProCab, Power Cab, the NCE logo with “Power of DCC” slogan and and the distinctive shape of the ProCab with thumbwheel and LCD are trademarks of NCE Corporation. Digitrax is a trademark of Digitrax Inc.