Removal - Siemens SINAMICS G130 Operating Instructions Manual

Basic operator panel 20

Hide thumbs Also See for SINAMICS G130:

Table of Contents

Installation

3.1 Removal

3.1

Removal

Please note the following information when removing the BOP20 from the Control Unit:

1. The latching cams on the BOP20 must be pressed together simultaneously.

2. The BOP20 must be pulled out straight (i.e. not at an angle). The bottom edge of the

Figure 3-1

BOP20 must never be pulled forwards to remove the device, as this could damage the

interface on the rear.

Incorrect mounting of the BOP20

Basic Operator Panel 20 (BOP20)

Operating Instructions, 03/2013, A5E00809375A

Table of Contents