Batteries; Troubleshooting - Eltax AVR-280 Instruction Manual

Troubleshooting

PROBLEM
Nothing happens, all displays are
dark.
Only the POWER LED is alight.
The system does not respond to
the remote control.
Systemet leverer ingen lyd.
No sound on the digital input.
The receiver does not receive the
radio station properly.
No reproduction of TV signals or
incorrect reproduction.
No reproduction of analogue
signals through AUX or incorrect
reproduction.
We reserve the right to change the technical data and design without notice as a result of further
development.
TROUBLESHOOTING
CAUSE/REMEDY
The mains plug has not been inserted (don't laugh -
check it out!)
There is no mains voltage. Check that the socket used
carries current (e.g. by means of a lamp).
The receiver is not switched on.
The receiver is in standby mode. Press the STANDBY key
on the remote control.
Check that no objects block the way between remote
control and receiver. Replace the remote control

batteries.

The cable connections of the speaker terminals are
loose or have no contact. Press the TEST key on the
remote control.
Check the setup settings. Set the DVD player in the
Setup menu. Set Audio out to the data format RAW or
bitstream. Check the digital input connected and select
it.
Check that the indoor antenna is correctly positioned and,
if the house connection is used, check that the signal is
correct. Check the cable for fracture.
Check the SCART connection, that the SCART cable is
fully mounted and that SCART IN/OUT has been
selected on the television set.
Check that that the RCA plugs are correctly inserted into
the inputs, that AUX 1 / AUX 2 have been properly
selected, and that the speaker volume is not set at 0 for
reproduction of portable devices (CD/MP3/MiniDisc
players)
20