Setup - Ip Mode Screen - Cisco RV220W User Manual

Setup - IP Mode Screen

You can either define your Router's time manually or automatically through Time Server.
Data - IP Mode Screen
IP Mode
This option utilizes IPv4 on the Internet and local network.
IPv4 Only
Dual-Stack IP This option utilizes IPv4 over the Internet and IPV4 and IPv6 on the
local network. Then select how the IPv6 hosts will connect to the
Internet:
•
•
Select the desired option to match your needs. Enter the related data in
6 to 4 Gateway
Access Control the following fields if required.
•
•
•
Figure 14: IP Mode Screen
NAPT-PT - This allows an IPv6-only host on your LAN to
connect to IPv4-only hosts on the WAN using address translation
and protocol-translation (per RFC2766).
6-4 Tunnel - This allows your IPv6 network to connect to other
IPv6 networks via tunnels through IPv4 (per RFC3056). The re-
mote router also needs to support 6to4.
Disabled
Permit following sites: Enter the IP addresses that you want to
permit in the following section.
Block following sites: Enter the IP addresses that you want to
block in the following section.
28