Central Address Setting - Panasonic CZ-ANC3 Installation Instructions Manual

Central Address Setting

* After the test operations for indoor units and outdoor units have fi nished, set the
central address.
 This unit is not equipped with the central address setting function.
 If using the unit in combination with central control devices (system controller, intelligent
controller, etc.) that can set the central address, set the central address using such devices.
(See "Installation Instructions" supplied with central control devices.)
 In a case other than the above, use a wired remote controller to set the address for each group.
Set the central address according to the following procedure.
Turn on this unit again after the setting is complete.
Setting from wired remote controllers (CZ-RTC4)
Make the setting while stopped.
1
Press and hold the 2 buttons for
several simultaneously.
2
Select the Code no. 03.
3
Select the Set data.
→
The indicator illuminates after blinking.
Press .
Setting from wired remote controllers (CZ-RTC3, CZ-RTC5, CZ-RTC5A)
1
Press and hold the 3 buttons for
4 seconds or more simultaneously.
, , ►
2
Select [Simple settings].
▲ ▼ →
3
Set.
Do not change the Unit No. from the
initial setting.
Select the Code no. 03.
Change the setting data, and set the
central address.
Press at the Unit No. selection
position to fi nish the setting.
2
A
3
1
13
(EN)