Emergency Messages - Ericsson R250d PRO User Manual

Dual band, tri mode for tdma systems
Hide thumbs Also See for R250d PRO:
Table of Contents

Advertisement

Emergency Messages

If your terminal is turned On when it receives an emer-
gency message, your terminal sounds two brief tones,
and a message similar to the one in this illustration is
shown in the display for a few seconds.
Reading Text Messages Immediately
When a message received notice is shown in the display,
you can read the message by pressing
through the message one line at a time by pressing and
Ö
releasing
or
the message three lines at a time by pressing and holding
Ö
Ó
or
.
Call-Back Messages
Some text messages you receive may be call-back mes-
sages. A call-back message contains one or more phone
numbers included by the person sending the message. If
you press
YES
similar to the one shown here appears. To dial the dis-
played number, press
the displayed number, press and hold
34
. You can scroll
YES
Ó
. You can scroll up or down through
while reading a call-back message, a screen
(to place a calling card call to
YES
). If you do not
YES
wish to call the displayed number, press
reading the actual message.
The up and down arrows in the top right part of the dis-
play indicate that there is more than one number in the
message. (The arrows would not appear if there were just
one number.) You can scroll through the available num-
Ö
Ó
bers by pressing
or
. When you see the desired
number, press
to dial that number.
YES
If you do not call back the number in the message, you
have the same options for saving and deleting the mes-
sage as you do with other text messages.
If you like, you can edit a displayed call-back number
before you make the call. In the display, the cursor
appears in reverse video, and it is initially positioned at
the far left of the second line. In editing the number, you
can:
• Enter a number at the cursor location by pressing a
number key. If a digit is already in the cursor loca-
tion, that digit, as well as all digits to its right, move
one position to the right.
• Clear the digit at the cursor location by pressing
.
CLR
• Move the cursor position without clearing anything
Ö
by pressing and holding
or
to resume
NO
Ó
.
Message Services

Advertisement

Table of Contents
loading

Table of Contents