Technicolor TG788v v3 Setup And User Manual page 28

2 The WPS LED starts blinking orange. This indicates that your TG788v v3 is now searching for wireless clients that are in
registration mode. You now have two minutes to start WPS on your wireless client.
3 Start WPS PBC on your wireless client.
4 Your TG788v v3 provides its wireless settings to the wireless client.
5 At the end of the WPS process, the status of the WPS LED on your TG788v v3 will change to either of the following:
Solid green

This indicates that you successfully registered and connected this wireless client. You are now connected to your
TG788v v3 wireless network.
 Blinking red
This indicates that your TG788v v3 could not find any wireless client in WPS pairing mode or that the exchange of the
wireless settings and/or registration failed. For more information, see
Connect your wireless client using WPS PIN code entry on the wireless client
Proceed as follows:
1 Check the label on your TG788v v3 and note the following information:
 The PIN code that is printed next to the WPS logo.
 The Network Name.
These are the default values. If you already changed these settings, use the new settings instead.
2 Go to the WPS PIN code entry page of your wireless client. Consult the documentation of your wireless client for more
information.
3 Enter the PIN code,
Do not include the hyphen when entering the PIN code. For example, if the PIN code is 1234-5678, then enter
12345678.
4 Your wireless client may prompt you to select your access point. If this is the case, your access point will be listed with its
Network Name.
You can find the default network name on the label on your TG788v v3.
Connect your wireless client using WPS PIN code entry on your TG788v v3
Proceed as follows:
1 Locate and note the WPS PIN of your wireless client. For more information, consult the documentation of your wireless
client.
2 Browse to the
For more information, see
3 Click Wireless. The Wireless page appears.
4 In the WPS Device PIN code box under Access Point, type the PIN code of your wireless client and click Set PIN code.
In case of problems
If you are having trouble connecting your wireless client via WPS, see
instructions.
DMS3-CTC-25-281 v2.0
TG788v v3 web interface.
"4.1.1 Accessing the TG788v v3 web interface from your local network" on page
"Cannot connect via WPS" on page
1234-5678
"Cannot connect via WPS" on page 75
3 Wireless networking
75.
33.
for more
24