Turn On Nmea Output And Confirm The Baud Rate; (For Devices Connected To The Sensor Pigtail Only); Set Up The Network And Alarms - Humminbird Trolling Motor 360 Imaging Installation Manual

6. Turn on NMEA 0183 Output and Confirm the Baud Rate

(for devices connected to the Sensor pigtail only)

If you connected a device to the Sensor pigtail wires, turn on NMEA 0183 Output to
enable communication and output NMEA 0183 sentences from the control head. It
is also important to note the following:
• If the GPS Receiver/Heading Sensor is connected to the control head, and
NMEA 0183 Output is turned on, the control head will operate exclusively
at a baud rate of 38400. If there is an accessory attached to the Sensor pigtail,
it also needs to operate at 38400. See your device's installation guide to set
the baud rate to 38400.
• If NMEA 0183 Output is turned off, then baud rates 4800, 9600, and 38400
are available on the control head, but the device will not receive NMEA data.
Turn On/Off NMEA 0183 Output
1. Main Menu: Press the MENU key twice.
2. Select the Setup tab > NMEA 0183 Output.
3. Select On or Off. (Default = Off)
NOTE: If the menu option is not shown under the Setup tab, make sure the User
Mode is set to Advanced (Setup tab > User Mode > Advanced).

7. Set up the Network and Alarms

After you have confirmed all connections, the 360 Imaging transducer is ready to use
on the water. Proceed to your 360 Operations Manual to set up the depth source,
temperature source, and the 360 Imaging Alarms.
Control Head Setup 44