Sony XCU-CG160 Technical Manual page 37

Category ( ) / Sub category (
Feature
*3
GainDigitalGreen
*3
GainDigitalBlue
GainAuto
GainAutoLevel
GainAutoSpeed
GainAutoLowerLimit
GainAutoUpperLimit
BlackLevel
*3
BalanceWhiteAuto
SpatialFilterEnable
SpatialFilterValueSelector
SpatialFilterValue
ColorTransformationEnable
ColorTransformationValueSelector
ColorTransformationValue
LUTControl
LUTEnable
LUTFormat
BinarizationThreshold
LinearInterpolationIndex
LinearInterpolationInValue
LinearInterpolationOutValue
LinearInterpolationBuild
LUTIndex
LUTValue
LUTValueSave
DigitalIOControl
LineSelector
LineMode
LineSource
LineInverter
LineStatus
*1 RO: Read only, WO: Write only, RW: Read/Write
*2 Color cameras are RO.
*3 Target models: Color cameras
*4 Enabled when color camera is set to BGR8, YCbCr8, or YCbCr422_8.
*5 Target camera mode: NORMAL
) Read/
Write
RW
RW
RW
RW
RW
RW
RW
RW
RW
RW
RW
RW
*4
RW
*4
RW
*4
RW
RO
RW
RW
RW
RW
RW
RW
WO
RW
RW
WO
RO
RW
RW
RW
RW
RO
Description
*1
Digital gain for the green channel.
Digital gain for the blue channel.
Sets automatic gain control (AGC) mode.
Sets the target level for Gain Auto and Exposure Auto mode. 15
Sets the automatic gain speed.
Sets the lower limit for the gain auto control.
Sets the upper limit for the gain auto control.
Controls the analog black level as an absolute physical value. –
Controls the mode for automatic white balancing between
the color channels.
Activates the 3×3 spatial filter.
Selects which physical line (or pin) of the external device
connector to control.
Controls the selected parameter for 3×3 spatial filter. 256
means ×1.0.
Activates the color transformation filter.
Selects which physical line (or pin) of the external device
connector to control.
Controls the selected parameter for color transformation
filter. 256 means ×1.0.
Category that includes LUT control features.
Activates the selected LUT.
Selects which LUT format is controlled among the various
LUT formats.
Controls the binarization threshold (12 bits).
Selects the index point to build a linear interpolation LUT.
Specifies the In value of the point selected by
LinearInterpolationIndex.
Specifies the Out value of the point selected by
LinearInterpolationIndex.
Builds a linear interpolation LUT.
Controls the index (offset) of the coefficient to access in the
selected LUT.
Returns the value at entry LUTIndex of the LUT selected by
LUTSelector.
Saves the value of the LUT to flash memory.
Category that contains the digital input and output
control features.
Selects the physical line (or pin) of the external device
connector or the virtual line of the Transport Layer to
configure.
Controls if the physical line is used to input or output a
signal.
Selects which internal acquisition or I/O source signal to
output on the selected line.
Controls the inversion of the signal of the selected input or
output line.
Returns the current status of the selected input or output line. 28
37
See
page
24
24
15
15
15
15
24
27
27
27
26
26
26
–
25
25
25
25
25
25
25
25
25
26
–
28
28
28
28