Zero Clearance Trim Support - Quadra-Fire 810-02901 Owner's Manual

Castile Pellet Insert
D. Zero Clearance Trim Support (Cont'd)
1. Remove contents from box and lay on protective surface
to avoid scratching the paint.
2. Lay zero clearance front and sides face down. Bend the
tab down toward the inside.
3. The side pieces are shipped fl at. It is much easier to
manually fl ex the sides into a bowed position before
installing.
4. Lay 1 cast ring face up, which will become the bottom ring
when installed. Attach the 2 sides FIRST and then the
front piece. Figure 20.1.
5. Now turn the cast ring right side up and attach the top cast
ring . Figure 20.2.
6. Attach the zero clearance panel extensions. Figure
20.3
7. Attach cast footers. Figure 20.4.
8. Place the assembled zero clearance trim support under
the insert. Figure 20.5.
Install Front Last
Bend top and bottom tabs toward inside
Figure 20.1
Turn right side up and attach top cast rin g
Figure 20.2
Alignment
Hole
Zero Clearance Panel Extension
Figure 20.3
Page 20
Cast Trim
Footer
Figure 20.4
Panel Leg
Figure 20.5
Base Plate Only Installation
Parts Needed: (1) cast ring (2) base zero clearance panel
extensions. Discard balance of parts.
Tools Needed: Phillips head screwdriver
1. Attach base zero clearance panel extensions to cast
ring.
2. Place assembly under appliance.
Cast Trim Footer
Figure 20.6
250-7251G
Panel Leg
Zero Clearance
Panel Extension
August 20, 2009
R