Before Machine Start-Up; Installing And Unloading The Brush / Pad-Holder - Viper AS510B User Manual

ENGLISH
14. Install the battery with specially made battery installation tools (A, Figure 7). After the battery is
installed, remove the battery installation tools, and install the battery fixation bracket (B, Figure 7).
15. Put the battery connector (C, Figure 7) through the hole on the top of the battery box cover, put
the draining hose through the right hole of the battery box cover, fix the battery box cover with 4
screws, and then install the squeegee drawing cord, draining hose, and the squeegee
successively.
Charging the battery
16. To charge the battery (refer to the steps stated in the maintenance section).

BEFORE MACHINE START-UP

INSTALLING AND UNLOADING THE BRUSH / PAD-HOLDER

NOTE
According to the type of floor to be cleaned, the machine may be installed with
brush (Figure8, A), or a pad-holder (Figure 8, B and C).
CAUTION ！
When manually installing or unloading the brush/pad-holder, first check if all the
switches are in the off position and lift the squeegee off the floor, only after which
can the brush or pad-holder be worked on. Furthermore, please put on protective
gloves to avoid being cut by fragments.
1. (Only applicable to AS430B and AS510B): make sure the
switch (41) is at the disconnecting (O) condition.
2. Press down the handlebar (2) to lift the tank body (26).
3. Put the brush (A) or the pad-holder (B – C) under the case.
4. Use the handlebar (2) to lower the tank body (26) to come
into contact with the brush or pad-holder.
5. To install the brush/pad-holder automatically, turn the
power switch (41) to the "I" position and press down the
safety switch (1). Gently push the machine forward so as
to allow the belt wheel at the bottom of the tank body to
align with the brush or pad-holder which can then be
installed. Then release the safety switch. If necessary,
repeat this procedure until the brush/pad-holder is installed.
6. If Step 5 above proves to be difficult, use the manual
method by following the arrow head (D) to install the brush/pad-holder (as shown in Figure 8).
7. To automatically unload the brush/pad-holder, turn the power switch (41) to the "O" position. Use
the hand to hold the handlebar, and press the machine downwards until the guide wheel touches
the floor and the brush/pad-holder hangs in the air. Turn the power switch (41) to the "I" position,
and press down the safety switch to let the brush or pad-holder turn until the brush/pad-holder
drops to the floor.
USER MANUAL
Figure 7
8
Figure 8