Table of Contents
Advertisement
USER MANUAL
MACHINE SET UP&INSTALLATION
UNCRATING MACHINE
Be sure and check packing carton for any damage. Immediately report any damage to carrier.
Check contents of package to ensure that the following items are included:
1. Machine
2. Batteries(x2)
3. Squeegee assembly
4. Scrubber-dryer User Manual
5. Electric Battery Charger Manual（if equipped）
6. connecting wire for battery and charger (if equipped)
7. brush or pad driver
BATTERY DISASSMBLY AND INSTALLATION
1. Switch off the main switch (47).
2. Remove the recovery tank (2) as shown in the relevant paragraph.
3. Unscrew the bolt from batteries (16), then remove or change.
4. Install the batteries on the machine according to the diagram below.
5. Install the recovery tank.
WARNING
Do not connect+ to +,or - to-,when disassembly or install the batteries. It is very dangerous.
Battery charging
Charge the batteries(see the procedure in Maintenance chapter).
MACHINE SET UP
Pre-operation checks
1． Sweep or dust mop the surface to be cleaned.
2． Check that squeegee is properly installed.
3． Lower the squeegee (33) with the lever(26).
4．
Check battery are fully charged.(see BATTERY CHARGING)
5． Check that brush/pad is properly installed.
Brush/Pad driver installation and disassembly
NOTE
Only install manually. If auto-installation, it will wear brush hub.
Make sure that the tanks are empty before disassembling the brush.
1.
Turn off the machine .
2.
Lay down the machine in this position as indicated in the figure2, Pull up the lift lever (26) to raise
the squeegee up (33) .
（if equipped）
2
Figure 1
Advertisement
Table of Contents
