Display Window Of Charger Indication Light; Guide For Use; Installing And Setting The Battery Of The New Machine - Viper AS510B User Manual

ENGLISH
DISPLAY WINDOW OF CHARGER INDICATION LIGHT (Figure 3)
(Optional, applicable to models with built-in charger)
1． When charging starts, the red indication light of the charger
(45)flashes a few times and then steadies to become a
permanent red indication light, entering into the first stage of
charging;
2． After charging for a period of time, the red indication light of
the charger (45) will go out, A yellow indication light (46) will
light up permanently: entering the second stage of charging;
3． After charging for approximately 10 hours, the amber
indication light (46) will turn off, (47) The green indication light
will become permanently lit, indicating that the charge is full,
and charging has ended.
NOTE
1) During charging, If the yellow indication light flashes: the battery is not of the
type compatible to the charger, or the battery is not properly connected, or a
short circuit has taken place at the output terminal.
2) If the red indication light is flashing: a short circuit inside the charger. (For
details, please refer to the related sections in the charger instruction.)

GUIDE FOR USE

WARNING
On certain parts of the machine are pasted some indicative signs:
－ DANGER
－ WARNING
－ CAUTION
－ CONSULTATION
When reading this manual, the operator must pay particular attentions to the symbols on these signs.
Under no circumstances shall these signs be covered. If they are damaged, please replace
immediately.

INSTALLING AND SETTING THE BATTERY OF THE NEW MACHINE

WARNING
If the battery is incorrectly installed or inaccurately connected, the electric
components of the machine may be seriously damaged. The battery may only be
installed by qualified personnel. According to the battery model number (WET or
GEL) being used, set the functional circuit board and on-board charger (optional).
Please check if the battery is damaged before installing.
Disconnect the battery connector and the on-board charger plug.
Be careful when touching the battery.
This machine needs two (2) 12V batteries. Please connect as shown
in Figure 4 on the right.
This machine can supply any of the following models:
a) Batteries（WET or GEL/ AGM） are already installed and can be
used at any time.
1. Check the battery. Through the connector (9) connect the battery to the
machine.
2. (Only applicable to AS430B and AS510B): Press down the on/off switch
(41). If the green light is on, it shows that the battery is ready for use.
If the amber or red light is on, it shows that the battery needs charging. (Please refer to the
section on maintenance for related procedures).
USER MANUAL
6
Figure 3
Figure 4