Wiring Instructions; Operating Instructions - Delta BreezRadiance RAD110LED Instructions Manual

WIRING INSTRUCTIONS

CAUTION:
• Make sure power is switched off at service panel before
starting installation.
• All electrical connections must be made in accordance with
local codes, ordinances, or national electrical code. If you
are unfamiliar with methods of installing electrical wiring,
secure the services of a qualified electrician.
WARNING:
This unit must be wired on a separate 20 amp circuit.
• If your house wires do not match these colors, you must
determine what each house wire represents before
connecting and you may need to consult an electrical
contractor to determine this safely.
1. Follow all local electrical and safety codes.
2. Never place a switch where it can be reached from a tub
shower.
3. Using wire nuts (not included), connect house power wires
to fan wires.
4. 12 AWG is the smallest conductor that may be used for
branch-circuit wiring. Each power wire (light, fan, heater)
must have its own switch to operate independently.
5. For supply connections, use wire rated for at least 90ºC.
See wiring diagram for wire size.

OPERATING INSTRUCTIONS

WARNING:
This unit must be properly installed before it is used. Follow instructions for cleaning, user-maintenance and
operations recommended by the manufacturer, such as lubrication or non lubrication. Any other servicing should be
performed by an authorized service representative.
1. Turn on the light switch to turn on the LED light.
2. Turn on the vent. switch to operate the fan mode.
3. Turn on the heat switch to operate the heater mode.
4. Adjust heater grille blade to provide heat in the desired direction.
9
l
40°