Sub Menu - Password Change; Sub Menu - Color Set - Q-See DVR User Manual

Q-See Q25DVR4ES User's Manual
Chapter 5: DVR Setup - 5.15 NTSC/PAL Output Selection
Change the J10 jumper on the system board to select NTSC or PAL video
output as marked on the silkscreen of the system board.
Chapter 5: DVR Setup - 5.16 Factory Reset
Press the [ SEL] Button to reload factory defaults, then the DVR will reboot, all custom
settings (including password) will be restored to default.
There is no confirming dialog box for this selection after you press [
will just reboot!
NTSC/PAL Select
SEL] button, the system
Page 15
Q-See Q25DVR4ES User's Manual
Chapter 5: DVR Setup - 5.10 Sub Menu-Password Change
System default password: Press [
Chapter 5: DVR Setup - 5.11 Sub Menu- Color Set
CH1] button six times.
User needs to enter six characters for the
password.
All keys can be used as password key except the
[ Menu] key, which is used to exit.
Note: To Reset the DVR.
Press the [Pause] button 10 times.
Resetting the DVR restores all values to system
defaults and the DVR will reboot.
Afterward the default password is [
button 6 times.
HUE : 0-99.
SATURATION : 0-99.
CONTRAST : 0-99.
BRIGHTNESS : 0-99.
Button function :
Down]: moves the prompt.
[ Up] [
[REW]: Increase Value.
[FWD]: Reduce Value.
[CH1-CH4, QUAD]: Select Channel.
[ Menu]: exit.
Page 12
CH1]