DataTrak Controls and Indicators
DataTrak Controls and Indicators
DataTrak is included with certain models. See page 3 for a list of models featuring DataTrak.
It is recommended that a 3/4 in. air line lubricator be used with DataTrak models.
For remote DataTrak models, see your system operation manuals.
To prevent damage to the soft key buttons, do not press the buttons with sharp objects such as pens, plastic
cards, or fingernails.
Key for F
. 3
IG
T
Runaway Limit, in cycles per minute (user settable;
00=OFF)
U
Lower Displacement (user settable)
V
Flow Rate Units (user settable to
gpm [Imperial], oz/min [US], oz/min [Imperial], l/min, or
cc/min)
W
LED (fault indicator when lit)
X
Diagnostic Reference Card (see T
Y
Display
Y; See Details at right.
F
. 3. DataTrak Controls and Indicators
IG
10
/min,
gpm [US],
1, page 13)
ABLE
RK
X
V
U
W
RK
TI8215a
PF Prime/Flush Key (Enables Prime/Flush mode. While in
Prime/Flush mode, runaway protection is disabled and
the batch totalizer [BT] will not count.)
RK Reset Key (Resets faults. Press and hold for 3 seconds to
clear the batch totalizer.)
CF Cycle/Flow Rate
BT Batch Totalizer
GT Grand Totalizer
RT Runaway Toggle (enable/disable)
UT E1 Toggle
DT E2 Toggle
ST E5 Toggle
Run Mode
CF
Setup Mode
T
GT
PF
BT
TI8622b
RT
UT
DT
ST
PF
TI8623b
311238ZAM