Figure 2-12. Transceiver Exploded View - Motorola PM1200 Installation Manual

2-10
2.2.1.2.2 Remote Radio Control Cable Installation
The radio control cable should go from the rear of the control head to the radio. Route the cables in
the vehicle's wiring troughs (where available) or route the cables where they are protected from
pinching, sharp edges, or crushing. One suggested route is along one side of the driveshaft hump
under the carpet. Use grommets in any holes where the cable passes through metal panels.
Figure 2-14 shows how the cables and components are connected.
2.2.1.2.3 Installing the Remote Radio Control Cable to Transceiver
1. Referring to
mating connector (red color connector) on the adapter unit.
2. Neatly bundle the exposed cable wiring, and then install the cable strain relief plate and
gasket into place using the supplied four screws.
3. Tighten the supplied four screws with suggested torque value of 5-6 in.lbs.
4. Perform the same procedure at the control head; insert the remote mount cable plug and
carefully insert the cable relief plate.
CAUTION:
-The plate can be installed to allow the cable to exit from left, right, up or down.
-Cut out the rubber gasket at the point from which you wish the cable to exit.
October, 2007
Figure 2-12, at the transceiver end, insert the remote mount cable plug into the

Figure 2-12. Transceiver Exploded View

Make sure that no wires stray into the screw holes, or are pinched between the plate
and adapter surface.
Standard Configurations: Radio Mounting
6880309U11