Placing Calls - Polycom CX300 User Manual

User Guide for the Polycom CX300 Desktop Phone

Placing Calls

Note
2 - 2
This chapter also provide information on:
• Using Your Phone with Microsoft Office Live Meeting
• Changing the Language
• Restarting Your Phone
To troubleshoot issues with the phone, refer to
on page 3-1.
This guide only describes how to use the Polycom CX300 desktop phone with
Microsoft Office Communicator 2007 R2. For more information on how to use
Office Communicator 2007 R2, refer to your Microsoft documentation.
If you require additional information or assistance with your new phone,
contact your system administrator.
To place a call using your Polycom CX300 desktop phone, dial the number
using the dial pad with the handset off-hook or on-hook.
During a call, you can alternate between handset, headset, or speakerphone
modes by pressing the Speakerphone or Headset keys, or picking up the
handset. If you are using the handset, press the Speakerphone or Headset
keys before you replace the handset. If you are using the speakerphone or
headset, just lift the handset to switch.
Call duration on an active call is monitored through a local call timer. This is
visible within the active call window on the graphic display. In the figure
below, the call to Sarah Smith has lasted two minutes and twenty seconds so
far.
With regard to the placement of emergency calls, consult your system
administrator.
To place international calls, enter "+". Press and hold the "0" key for 1.5 seconds.
The "0" button must be the first digit pressed for the "+" for international dialing to
display. Microsoft Office Communicator 2007 R2 will replace the "+" with the access
numbers required to dial an international phone number.
If dialing rules are set up for Microsoft Office Communicator 2007 R2, then these
rules also apply to your phone.
Troubleshooting Your Phone