Disc Play; Preparing The Remote Control - Pyle PLCD95UM Instruction Manual

NOTES

DISC PLAY:

CLEANING DISCS
Before playing, clean the disc with a clean, lint-free.
Flip the disc in the direction of the arrow.
NOTE 1:
Do not use so solvents such as benzine, thinners. Commercially available
cleaners or anti static spray damage the unit.
Insert a disc with the label surface down. Doing so may damage the unit.
NOTE 2:
Do not try to insert another disc when one has been already inserted.
Doing so may damage the unit.
Handle the disc by its edge. And to keep the disc clean, do not touch the
surface.
Do not stick paper or tape on the disc.
Do not expose the disc to direct sunlight or heat sources such as hot air ducts.
Or leave it in a car parked in direct sunlight where there can be a considerable
rise in temperature.

PREPARING THE REMOTE CONTROL

INSERTING THE BATTERIES
1.Open the battery compartment cover.
2.Insert the new batteries. Make sure
that the positive and negative terminals
of the batteries are oriented indicated.
3.Close the cover
USING THE REMOTE CONTROL
Face the remote control towards the
player front face IR mark (remote
control signal receiver).
Operation angle: About +30 degree
in each the direction of the front of
the IR mark.
Label
surface up
9