Capresso EC300 123.05 Instruction Manual page 13

NOTE: If no steam comes out of the frothing wand, hardened milk
blocks its path. Turn the Control Knob back to the "O" position.
Remove the black frothing sleeve and carefully use a needle to loosen
the milk residue from the opening of the frothing tip (Fig. 4) to remove
any blockage, then steam again.
NOTE: In order for your machine to work properly time after time, clean
the frothing wand, sleeve and tip after each use as described above.
8c. Decalcifying
When making espresso always use cold, clean water. Using spring water or
filtered water will slow down calcium build up. We recommend decalcifying
the machine after 100-200 uses or at least every 2-3 months.
• When using commercial decalcifying agents it is important to follow their
instructions. You can also use Capresso Cleaning Solution, available at
www.capresso.com. Dissolve 1 packet of Capresso Cleaning Solution
with 30 oz. of water and add to the water tank.
NOTE: Do not use vinegar as this will considerably shorten the life of the
seal inside the brew head.
Decalcifying the Brew Head
1. Remove the portafilter.
2. For best results unscrew the screen inside the brew head. Wipe off any
coffee residue with a damp cloth.
3. Fill the water tank with the decalcifying solution.
4. Place a large bowl beneath the brew head.
5. Push the Power Button on the side of the machine and turn the Control
Knob to the left towards the "Cup icon". Allow 1/3 to 1/2 of the solution
to be pumped through the system and the brew head.
6. Turn the Control Knob back towards "O" position to stop the process.
7. Let the machine sit for approximately 10 minutes.
Decalcifying the frothing wand
8. Remove the black frothing sleeve.
9. Fill a pitcher with 6 to 8 oz. of cold water and immerse the frothing
wand into the cold water.
10. Turn the Control Knob to the right towards the "Steam icon" and let
the steam pass through for about 30 seconds. Repeat this process
three or four times.
11. Now process the remaining decalcifying solution through the brew
head as described above.
Rinsing the system
12. Remove the water tank and rinse thoroughly, then fill with fresh cold water.
13. Repeat above steps (4 through 6) with fresh cold water.
14. Replace screen in the brew head and tighten the screw securely.
13.