Precautions When Using The Network Configurator - Omron CS1W-EIP21 Operation Manual

Network Configurator Overview
1-4-3

Precautions When Using the Network Configurator

20
• OMRON 3G8F5-DRM21 DeviceNet ISA Board
• OMRON 3G8E2-DRM21 DeviceNet PCMCIA Card
Only an OMRON EtherNet/IP Unit can be set as the originator for a connec-
tion using the Network Configurator.
• The Network Configurator can be connected to the EtherNet/IP network
through the following ports:
• CS/CJ-series CPU Unit's serial port (peripheral or RS-232C)
• NE1S-series CPU Unit's serial port (USB or RS-232C) or Ethernet
port
• NE1S-series DeviceNet Unit's DeviceNet port
(One of the following Interface Boards or Cards is required to connect
through DeviceNet: 3G8F7-DRM21 DeviceNet PCI Board, 3G8F5-
DRM21 DeviceNet ISA Board, or 3G8E2-DRM21 DeviceNet PCMCIA
Card.)
• NE1S-series ControlNet Unit's ControlNet port (See note 2.)
(The following interface card and software are required to connect
through an RSLinx interface: an Allen-Bradley 1784-PCC Communi-
cation Card and a Rockwell RSLinx 2.1 Software.)
• The Network Configurator can be connected directly to the EtherNet/IP
network from the computer's Ethernet port. When connecting directly to
the EtherNet/IP network, an Ethernet port must be set up in the computer
in advance. In this case, the Network Configurator will be connected to
the EtherNet/IP network as a single node. If there isn't an unused node
address available, the Network Configurator can't be connected directly to
the EtherNet/IP network.
Section 1-4