Connecting An External Decoder Box (2) - Pioneer DVR-940HX-S Operating Instructions Manual

02 Connecting up
Connecting an external
decoder box (2)
If you only have a decoder, connect it to this
recorder and your TV as shown on this
1
page.
Using the setup on this page you can:
• Record scrambled channels received
using the recorder's built-in analog TV
tuner.
Important
• Do not connect this recorder 'through'
your VCR, satellite receiver or cable box.
Always connect each component
directly to your TV or AV amplifier/
receiver.
Note
1 In order to use this setup, you will need to make the following settings from the Initial Setup menu:
• Set the AV2/L1 In setting to Decoder from the Initial Setup menu (see AV2/L1 In on page 142).
22
• From the Manual CH Setting screen, set the Decoder setting for the scrambled channels to On (see Manual
CH Setting on page 140).
En
SCART AV
CONNECTOR
2
COMPONENT
VIDEO OUT
P R P B
AV 2 (INPUT 1/DECODER)
AC IN OUTPUT
AV 1 (RGB) – TV R L
AUDIO
3
SCART AV
CONNECTOR
1 Connect your TV antenna to the
recorder and TV.
See Connecting a TV antenna on page 16 for
details.
2 Use a SCART cable (not supplied) to
connect the AV1(RGB)-TV AV connector
to a SCART AV connector on your TV.
This enables you to watch discs.
3 Use another SCART cable to connect
the AV2(INPUT 1/DECODER) AV
connector to a SCART AV connector on
your decoder box.
This enables you to record scrambled TV
channels.
TV
OUT
IN
Y
ANTENNA
CONTROL G-LINK (DIGITAL)
S-VIDEO
IN
DIGITAL
AUDIO OUT
IN
OUT
ANTENNA
INPUT3
VIDEO COAXIAL
COMMON INTERFACE
Decoder