Battery charger with trickle charge function (27 pages)
Summary of Contents for Mercedes-Benz Hands-free system
Page 1
® Bluetooth hands-free system Operating Instructions...
Page 2
Symbols Warning Environmental note Possible vehicle damage Instructions Continuation symbol (Y page) Page reference Display Messages in the display...
Page 3
Thank you for choosing the Mercedes- Benz hands-free system. Before you drive off, familiarise yourself with your hands-free system and read the operat- ing instructions. This will allow you to fully enjoy your hands-free system and avoid endangering yourself and others.
The equipment conforms to the relevant Proper use equipment-specific EMC specifications in Always observe the safety information in this accordance with the following European manual when using the hands-free system standards: and your mobile phone: EN 55013 If work on electronic equipment and its...
( page 19). Radio fittings The hands-free system is fitted at the fac- tory. Only preparations for fitting the radio are provided. The call volume is set using the +/- buttons on the hands-free system.
Page 11
Overview of controls Function Page Function Page Press briefly: Press briefly: rejects a call accepts a call ends a call toggles ® redials calls up the Bluetooth sta- Press and hold (with the pauses audio playback ~ button): Press and hold (with the pairs the mobile phone 6 button): ®...
Displays Basic functions ® Activating Display of Bluetooth function The hands-free system is activated automat- Blue status LED C, informs on the status of ically with the vehicle ignition. The button illu- ® the Bluetooth connection. mination is only switched on in night mode.
To insert: position the charging bracket If there is an incoming call, the hands-free onto the catch lug of the hands-free system system switches over to the telephone auto- moving from the bottom to the top. matically. After the call has ended, the hands-...
Press the 6 "Accept" button and the ~ "End call" button simultaneously for The mobile phone will connect automatically at least three seconds. to the hands-free system in the future, if you The blue status LED now flashes slowly and ® are in the Bluetooth...
The blue Bluetooth LED flashes slowly and ® the Bluetooth connection is interrupted. The hands-free system remains visible for reconnection, however, the"Automatic reconnection" function is deactivated. A new connection must be established via the mobile phone. To reconnect: select the hands-free sys- ®...
During an incoming call or an active call, you can interrupt the audio connection between Press the ~ button. the mobile phone and the hands-free system. The conversation is then conducted via the mobile phone and not over the vehicle speak- ers (private mode).
A recorded message prompts you to trans- lowing Bluetooth hands-free system func- mit the vehicle identification data. tions using the steering wheel buttons: To start data transmission: press the accepting a call Service 24 h button again.
Page 22
(see vehicle Operating Instructions). The volume is increases or decreases. On the Radio fittings version, the call volume of the hands-free system increases automat- ically as the vehicle speed rises. The set call volume is stored permanently. Changing the call volume on the mobile phone is not possible in hands-free mode.
Page 23
Internet Further information about Mercedes-Benz vehicles and about Daimler can be found on the following websites: www.mercedes-benz.com www.daimler.com Editorial office You are welcome to forward any queries or suggestions you may have regarding this Sup- plement to the technical documentation team...
Page 24
É0045847181vËÍ 0045847181 Order no. 6462 2601 02 Part no. 004 584 71 81 Edition A, 02/09...