Installation; Faucet Assembly - Westinghouse QL0193 Owner's Manual

Installation

FAUCET ASSEMBLY

1 . Thread the hose (D) through the pipe (T) inserting first the small
fitting (G).
2 . Thread the hose through the body (M) of the faucet also inserting first
the small fitting (G).
3 . Insert the end of the pipe that has the nut (N) onto the body of the
faucet . Hand tighten clockwise .
4 . With one hand, hold the end of the hose (D) that has the large fitting
(P) . With the other hand, tighten the faucet head (Q) onto the large
fitting (P) clockwise.
5 . Unscrew the retaining ring (H) from the bottom of the faucet and
ensure the washer (A) and gasket (B) are also kept with the ring (H) .
6 . Install the faucet through the hole on the sink, by first threading the
flexible hose (D) through the hole, then place the base of the faucet
through the hole . A second person may be required to hold this in
place until the faucet installation is complete .
7 . From underneath, slide the gasket and washer (B + A) and the
retaining ring (H) over the free end of the flexible hose (D) and slide it
up to the exposed threaded section of the faucet (E) .
8 . Tighten the retaining ring (H) by hand until it is snug . Using a wrench
or pliers, tighten the assembly . Do not over tighten . Gently tighten the
2 screws on the retaining ring (H) .
9 . Attach the free end (G) of the flexible hose onto the faucet outlet (F).
10 . Install the counter-weight (C) on the flexible hose (D) approximately
30" (76 .2 cm) down from the underside of the faucet . This can be
adjusted based on your own requirements, but this is the normal
location .
11 . Screw lever (J) into the handle body (L) . If the handle body (L)
becomes loose over time, remove the lever (J) and using the supplied
Allen key, tighten the screw (K) that is inside .
QL0193
T
N
D
M
30"
(76.2 cm)
C
6
P
D
Q
J
K
L
E
B
A
H
F
G
D