Table of Contents
Advertisement
SETUP
S c h e d u l e r
S i g n a l C h e c k P r i o r i t y
C E C C o n t r o l
S l e e p Ti m e r
P o w e r S a v e
S o f t w a r e U p d a t e ( U S B )
R e s t o r e D e f a u l t
Move
Back
SETUP
Scheduler
Signal Check Priority
CEC Control
Sleep Timer
Power Save
Software Update (USB)
Restore Default
32 | OSD (On-Screen-Display) Controls
S e t u p
Menu
Change the Scheduler setting.
• The schedule function allows the display to be set to power on
and off at different times. Up to seven different schedules can be
programmed.
• If schedules are overlapping then the schedule with the highest
number will have priority over the schedule with the lowest
number. For example schedule #7 will have priority over
schedule #1.
When Signal Check Priority is enabled, the display attempts to
find a valid signal source according to the Signal Check Priority
setting at power on.
• Set PRIORITY 1 to PRIORITY 5 (PRIORITY 1: highest priority)
as the priority of each signal. When the current source signal is
lost, the display attempts to find a new signal source according to
the Signal Check Priority setting.
• When the signal source for which PRIORITY 1 is set is not
found, the display checks other sources in order of priority and
switches to the available source with the highest priority.
• When the signal source with the highest priority recovers, the
display automatically switches to the source again.
• When Signal Check Priority is disabled, the display uses the
last used source at power on.
• When Signal Check Priority is enabled and the signal source is
USB, the USB data is automatically played at power on.
Select CEC Control settings to ON or OFF.
Change the Sleep Timer setting or set Sleep Timer to OFF.
Change the Power Save setting or set Power Save Mode to OFF.
Updates software via the USB port.
Resets the settings in the Setup menu back to their factory settings.
O ff
O n
O ff
3 0 0 S e c
Adjust
Exit
FUNCTION
Advertisement
Table of Contents
