Mounting Equipment; Attaching Mounting Equipment To Your Display - Acer DT653 User Manual

Mounting Equipment

This display cannot be used or installed without a support stand or a mounting support
accessory.
The display is designed for use with the VESA mounting system. When using mounting
accessories other than those that are approved by the dealer, they must comply with the VESA-
compatible (FDMlv1) mounting method. It is recommended to use mounting interfaces that comply
with UL1678 standard in North America.

Attaching Mounting Equipment to Your Display

For proper installation it is strongly recommended to use a trained, qualified technician.
Refer to the proper installation instructions included with the mounting equipment.
1. Place the display face-down on a flat, padded surface for safe installation of mounting
accessories.
2. For installation, it is recommended to use M6 screws and tighten them securely. Screws should
have a Boss screw thread of at least 15mm, a loose-proof spring washer, and a length 10 mm
longer than the thickness of the mounting bracket.
(Recommended Torque: 470 - 635N·cm). Bracket hole should be under φ8.5 mm.
CAUTION
NOTE
Installation of Your Display | 13