Lowrance FishHunter 3D/PRO Operator's Manual page 12

10.
11.
The unit will automatically power down and turn off when not
in the water after a few minutes. If the lights remain on after it
is removed from water, ensure the charging pins are free from
any water or debris by blowing on them. Additionally, you can
insert and remove the charging cord and that should enable
the sonar to power down after 60 seconds. If the unit still
remains on, then double check that your wifi is turned off and
repeat the above.
You can reset your sonar at any time by inserting the charge
cord into the bottom of the unit and removing it.
Wi-Fi connectivity and FishHunter
In order for you to get the best possible signal and connection
with your FishHunter, we recommend that you follow the
instructions below.
12 |
If you are connected to your FishHunter correctly, you
will see the following options:
•
Directional Casting*
•
Bottom Mapping*
•
3D Contour*
The slow red flashing light on your sonar will start
flashing quickly when connected and sending
information to your phone or tablet.
Overview | FishHunter 3D/PRO Operator Manual
•
Bathymetric Mapping*
•
Ice Fishing Flasher
•
Switch Device