ADT Garda Response PM30 Reference Manual page 3

Resetting/ Silencing Your System After An Alarm
To stop the alarm sounding by:
Option 1:
The Keypad – by pressing the "part-set" key and presenting your KeyTag /or entering
your 4-Digit User Code.
Option 2:
The Alarm Panel – by pressing the "part-set" key and entering your 4-Digit User code.
Important: Resetting/Silencing your System stops the Internal Siren ringing but will
not interrupt the transmission of the alarm signal to the ADT Alarm Monitoring Centre.
Our monitoring specialists may contact you at this point and you will be requested
to confirm your Verification Code /Password to cancel the alarm alert. Your System
might require a remote reset.
Changing/Deleting Master And User Codes
Using the Alarm Panel only
1. If ADT Screen Saver is displayed press the 'Open Padlock key followed by the
manager code
2. The screen will now display 'Ready'
3. Press the 'Forwards Button' until the display shows 'User Settings'. Press 'OK'
button
4. The display will now show 'Set Zone Bypass'
5. Press 'Forward Button' until 'User Codes' is displayed and press 'OK'
6. Display will now show 'User 01 Code' and a black box will be showing.
7. Using the 'Forward Button' press until you get to the code you want to change or
add. Once there press the 'OK' button
8. The display will show the code already installed or the display will be blank.
To delete a user code
9a. To erase the code enter '0000' and press 'OK' button, you will hear a 'Happy
Beep' and the display will show the user number but no code will be shown. Move
to step 10
To enter a new user code
9b. Overtype the existing code with the new code and this should be displayed for
you. If correct then press the 'OK' button. You will hear a 'Happy Beep' and the
display will now show the user number followed by a black box. Move to step 10
10. To escape from the user setting and go back to ADT/Ready press the 'Closed
Padlock' button
11. The display will show 'OK to Exit' at this point press the 'OK' button
3