Safety Instructions For Maintenance; Assembly; Operation - Jonsered LM 2146 CMD Operator's Manual

WARNING: Read the warning instructions
that follow before you use the product.
• The exhaust fumes from the engine contain carbon
monoxide, an odourless, poisonous and very
dangerous gas. Do not start the engine indoors or in
closed spaces.
• Before you do the maintenance on the product, stop
the engine and remove the ignition cable from the
spark plug.
• Use protective gloves when you do maintenance on
the cutting equipment. The blade is very sharp and
cuts can easily occur.
To assemble the handle
1. Align the screw holes at the bottom of the lower
handle with the screw holes in the lower handle
assembly on the deck.
2. Attach the screws, washers and knobs.(Fig. 28 )
3. Use the straps to attach the cables to the handle.
(Fig. 29 )
Note: Make sure that the tension in the cables is not
too high.
4. To set the handle height, loosen the lower knobs, lift
or lower the handle to adjust the height, and then
tighten the knobs fully.(Fig. 30 )
To install the starter rope
1. Attach the loop for the starter rope and the T-knob,
but do not tighten fully.(Fig. 31 )
2. Hold the engine brake handle against the handlebar.
3. Slowly pull out the starter rope and put it into the
loop for the starter rope.(Fig. 32 )
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
Before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
10

Safety instructions for maintenance

Assembly

Operation

• Accessories and changes to the product that are not
approved by the manufacturer, can cause serious
injury or death. Do not change the product. Always
use accessories that are approved by the
manufacturer.
• If the maintenance is not done correctly and
regularly, the risk of injury and damage to the
product increases.
• Only do the maintenance as given in this owner's
manual. All other servicing must be done by an
approved Jonsered service agent.
• Let an approved Jonsered service agent do servicing
on the product regularly.
• Replace damaged, worn or broken parts.
4. Tighten the T-knob.(Fig. 33 )
To assemble the grass catcher
1. Put the upper part of the grass catcher onto the
lower part of the grass catcher.
2. Attach the grass catcher frame with the clips.(Fig.
34 )
3. Lift the rear cover.
4. Attach the hooks on the grass catcher to the top
edge of the chassis.(Fig. 35 )
5. Put the lower part of the grass catcher into the grass
discharge channel.
To assemble the mulch plug
1. Lift up the rear cover and remove the grass catcher.
2. Put the mulch plug into the discharge channel.(Fig.
36 )
2. Examine the cutting equipment to make sure that it
is correctly attached and adjusted. See
the cutting equipment on page 12 .
3. Fill the fuel tank. See
4. Fill the oil tank and do a check of the oil level. See
To do a check of the oil level on page 13 .
To fill fuel
If available, use low-emission/alkylate gasoline. If low-
emission/alkylate gasoline is not available, use good
To examine
To fill fuel on page 10 .
349 - 003 - 24.10.2017