Modifying And Saving A Configuration - Alcatel-Lucent 7210 SAS M Basic System Configuration Manual

Modifying and Saving a Configuration

If you modify a configuration file, the changes remain in effect only during the current power
cycle unless a
router is rebooted without saving.
•
•
•
•
The following command saves a configuration:
CLI Syntax: bof# save [cflash-id]
Example
The following command saves the system configuration:
CLI Syntax: admin# save [file-url] [detail] [index]
Example
NOTE: If the
executed with an FTP path used as the
open to the FTP server. The FTP server must be configured to allow multiple sessions from the
same login, otherwise, the configuration and index files will not be saved correctly.
7210 SAS M, X Basic System Configuration Guide
command is executed. Changes are lost if the system is powered down or the
save
Specify the file URL location to save the running configuration. If a destination is not
specified, the files are saved to the location where the files were found for that boot
sequence. The same configuration can be saved with different file names to the same
location or to different locations.
The detail option adds the default parameters to the saved configuration.
The index option forces a save of the index file.
Changing the active and standby addresses without reboot standby CPM may cause a
boot-env sync to fail.
: A:
ALA-1# bof
A:
ALA-1>bof# save cf1:
A:
ALA-1>bof#
: A:
ALA-1# admin save cf1:\test123.cfg
Saving config.# Saved to cf1:\test123.cfg
... complete
A:
ALA-1#
option is enabled and the
persist admin save file-url
parameter, two FTP sessions simultaneously
file-url
Boot Option Files
command is
Page 117