PSC PT2000TM User Manual page 32

Using the PT2000 and Top Gun with PALPRO
Using the
Keyboard
Wedge
Figure 3-7: The PALPRO Options Menu
22
Attach the other end to the 25-pin connector of the keyboard
2.
wedge cable (refer to
PC: Attach the small male plug of the PSC cable to the keyboard
3.
jack on the PC (refer to
Terminal: Insert the keyboard cable plug into the modular jack
on the PSC cable connector.
4. PC: Attach the keyboard cable to the small female jack on the
PSC cable (refer to
Terminal: Insert the modular plug of the PSC cable into the
keyboard input jack on the terminal.
Scan the appropriate bar code below:
5.
AT or PS/2 models
30-286, 50, 50Z, 60,
70, 80, 90, 95 (U.S.
keyboard)
IBM 3151 terminal
To use the PT2000 or Top Gun as a keyboard wedge, complete the
setup and installation procedures described earlier in this chapter. Then
complete the following steps:
1. From the
PALPRO Options
Open the application and place the cursor at the location where
2.
the data is to be entered.
Figure 3-6 on page 21
Figure 3-6
).
Figure 3-6
*$+$-D2C011EE*
*$+$-D2C015EE*
menu, select
PALPRO OPTIONS
F2=SELECT PROG
F3=WEDGE
¤
F4=PASSWORD
).
).
.
<F3>
PT2000 & Top Gun PDTs