Preparing Your Stand Mixer; Before Initial Use; Attaching The Rotating Turntable; Placing The Mixing Bowl - Homemaker HM-09 User Manual

5

PREPARING YOUR STAND MIXER

5.1

BEFORE INITIAL USE:


Unpack the mixer and wash the mixing bowls, beaters, dough hooks, whisk,
measuring bowl and plastic spatula in hot soapy water.

After washing parts, rinse and dry thoroughly. Wipe the mixer housing with a
damp cloth or sponge to remove any packaging dust.

NEVER immerse base, cord or plug in water or other liquids.

Do Not use harsh cleaning chemicals or abrasive cleaners on any parts of the
stand mixer.
5.2

ATTACHING THE ROTATING TURNTABLE:


Place stand mixer on a flat, level surface.
DO NOT PLUG IN UNTIL THE MIXER IS COMPLETELY ASSEMBLED.

Place the rotating turntable into position, by fitting the turntable into the correct
hex shaped slot in the base of the mixer for the corresponding mixing bowl.
Note: The hex slot closer to the scale is for the large mixing bowl and the
other hex slot is for the small mixing bowl.
5.3

PLACING THE MIXING BOWL:


Place the corresponding mixing bowl on top of the rotating turntable.
Note: The mixing bowls should not be used in a conventional oven, in a
microwave oven, on top of the range or on any other heated surface.
Mixing bowls should not be used to mix hot liquids.
5.4

ATTACHING THE BEATERS:


Make sure the sliding ON/OFF switch is in the OFF position and the power
cord is unplugged from the wall outlet.

Using the TILT button, release the motor head into the up (titled) position.
NOTE: The beaters can be placed in either receptacle. Read the following
carefully to avoid damaging the mixer or ruining your recipe.
Page 7 of 13