6.18
F14 Flashing of module
Special tools:
►
IS (BSH IService)
►
UDA KIT (341247)
Prerequisite:
►
Work plate is demounted
►
Control panel is unlatched
►
Module(s) is (are) exchanged
Procedure:
1.
connect the Y-cable to the operation and power modul and the
UDA
1
UDA
2
D-Bus to power module
3
Operating module
2.
Connect the appliance to power network and switch it on
209_58300000178575_ARA_EN_C.doc – 30.06.2015
Symbol Meaning
It is NOT NECESSARY to flash both modules after
changing one of them
3.
Retrieve IService and proceed according to instructions.
See chapter IService
6.18.1 Flashing of operating module:
Turn function selector one position to the right
4.
No information in the display
5.
Flash the operating module
6.
Switch the appliance off and wait 3 sec.
7.
Switch the appliance on (Err appears in the display, uPD and
0:00).
Page 59 de 70