Bosch WAQ283S1GB Repair Instruction page 51

6.13.3 Assembly without torque wrench: nut 24 or nut 18
Cutting edges:
Use protection gloves
►
Tighten the collar nut on the belt pulley hand-tight.
►
Fix the pulley in position using auxiliary tool (B).
►
For FD <= 9504 Tighten the collar nut firmly using the 24-mm
ring spanner (A). Then attach ring spanner again and turn it
up to a ¼ turn further (approx. 20°) if possible. This will enable
a torque of 75 Nm to be achieved. The union nut is not
overloaded as it can withstand up to 130 Nm.
►
For FD > 9505 Tighten the elastic nut firmly using the 18-mm
ring spanner (A). Then attach ring spanner again and turn it
up to a ¼ turn further (approx. 50°) if possible. This will enable
a torque of 90 Nm to be achieved.
►
Remove the auxiliary tool, hoist belt and make sure that it is
seated correctly.
►
Fit the rear panel.
209_58300000178575_ARA_EN_C.doc – 30.06.2015
A 24 ring spanner -
341221
18 ring spanner-
15000104
B Auxiliary tool 341238
Page 51 de 70