Table of Contents
Advertisement
3. With the help of a second person, carefully tip the tread-
mill onto its right or left side.
Align the hole in the Base Shock (109) with the holes in
the bracket on the Small Crossbar (108). It may be nec-
essary to grasp the Small Crossbar and pivot it back and
forth slightly. Attach the end of the Base Shock to the
bracket with a 1/4" x 1" Bolt (106) and a 1/4" Nut (107).
Tighten the Bolt.
With the help of a second person, carefully tip the tread-
mill back to the upright position.
4. Attach the Right Side Cover (67) to the Right Upright
(46) with three 1 3/4" Side Cover Screws (64).
Attach the Left Side Cover to the Left Upright in the
same manner (not shown).
5. Remove the paper backing from the Adhesive Clip
(115). Press the Adhesive Clip onto the Left Rear
Endcap (88) in the indicated location. Press the Allen
Wrench (114) into the Adhesive Clip.
6. Attach the Pulse Sensor (4) to one of the Headbands
(59 or 60). Make sure that the sensor window is
pressed through the indicated hole in the Headband.
The use of the pulse sensor is explained on pages 8
and 9.
Make sure that all parts are properly tightened before you use the treadmill. Important: Place a mat beneath the
treadmill to protect the floor or carpet.
3
108
4
67
64
5
88
114
115
6
Sensor
Window
Hole
4
106
109
107
46
64
59 or 60
7
Hide quick links:
Advertisement
Table of Contents
