Cirrus SR22 Pilot Operating Handbook page 309

Cirrus Design
SR22
Do not fill tank within 100 feet (30.5 meters) of any energized
electrical equipment capable of producing a spark.
Permit no smoking or open flame within 100 feet (30.5 meters)
of airplane or refuel vehicle.
Do not operate radios or electrical equipment during refuel
operations. Do not operate any electrical switches.
To refuel airplane:
1. Place fire extinguisher near fuel tank being filled.
2. Connect ground wire from refuel nozzle to airplane exhaust, from
airplane exhaust to fuel truck or cart, and from fuel truck or cart to
a suitable earth ground.
3. Place rubber protective cover over wing around fuel filler.
Do not permit fuel nozzle to come in contact with bottom of
fuel tanks. Keep fuel tanks at least half full at all times to
minimize condensation and moisture accumulation in tanks. In
extremely humid areas, the fuel supply should be checked
frequently and drained of condensation to prevent possible
distribution problems.
4. Remove fuel filler cap and fuel airplane to desired level.
If fuel is going to be added to only one tank, the tank being
serviced should be filled to the same level as the opposite
tank. This will aid in keeping fuel loads balanced.
5. Remove nozzle, install filler cap, and remove protective cover.
6. Repeat refuel procedure for opposite wing.
7. Remove ground wires.
8. Remove fire extinguisher.
P/N 13772-001
Revision A9
Handling, Servicing, Maintenance
• Note •
• Note •
Section 8
8-23