Rinnai RB-7022HE-CB Operation & Installation Manual page 12

FASTENING THE COOKTOP
Each cooktop is supplied with a set of tabs and screws
to fasten it on units with a working surface from 3 to 4
cm deep.
The kit includes 4 tabs A and 4 self-threading screws B
(fig. 4.4)
• Cut the unit
• Turn the hob upside down and rest the glass side on
a cloth.
• Spread the seal C around the edge of the hob(fig. 4.5)
• Put tabs A into the mountings; only tighten screws B
a few turns.
• Make sure that the tabs are mounted correctly as
shown in the figure 4.4
• Put the cooktop into the hole cut into the unit and
position it correctly.
• Put tabs A into place, tooth D of the tabs should go
into the hole.
• Tighten screws B until the cooktop is completely
secured.
• Using a sharp tool cut off the part of gasket C which
protrudes from the cooktop. Take care not to damage
the workbench.
9