Assembly - ProForm PFTL58590 User Manual

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
treadmill to the upright position.
While the other person tips the treadmill to one side and
holds it, insert an Extension Leg (59) into one side of
the treadmill. Make sure that the Extension Leg is
turned so the bracket is on the top as shown. Using the
Allen Wrench (102), Attach the Extension Leg with an
Extension Leg Screw (57). Attach the other Extension
Leg in the same manner.
Note: One replacement Base Pad (55) may be included.
Use the extra Pad if one becomes worn or needs to be
replaced.
2. Refer to HOW TO LOWER THE TREADMILL FOR
USE on page 11. Follow the instructions in step 2 to
lower the treadmill.
Cut the plastic ties holding the cage nuts in the upper
end of each Handrail (60, 62).
Position the Left Handrail (60) on the left Upright (32) as
shown. The bracket on the Extension Leg (59) should
be inside of the lower end of the Left Handrail (see the
inset drawing). Thread two Handrail Bolts (30) with
Handrail Washers (40) into the left Upright and the Left
Handrail. Do not tighten the Handrail Bolts yet.
While another person holds the Console Base (46),
insert all excess Wire Harness (35) through the Right
Handrail (62) and into the right Upright. Next, attach the
Right Handrail in the same way that you attached the
Left Handrail. Be careful to avoid damaging the Wire
Harness (35).
, adjustable wrench
1
102
2
30
40
32
59
, and scissors
Bracket
57
55
60
30
40
30
59
.
59
46
35
62
30
5