How To Swing The Control Box To The Front - Mitsubishi Electric EHSE-YM9EC Service Manual

DISASSEMBLY PROCEDURE

4. How to swing the control box to the front

(1) Remove the front panel. (Refer to Procedure 1.)
(2) R emove the screw from the control box bracket (R) and 2
screws from the control box bracket (L). (Photo 4-1)
(3) D isengage the control box bracket (R) from the right-hand
side panel and pull the control box. At this point, lifting
slightly and pulling the control box will swing the control
box to the front. (Photo 4-2)
(4) Release the coated clamp. (Photo 4-2)
Note: Remove the field wiring as necessary.
OCH590B
Photo 4-1
Screws
Note: The photos shown are of the E*SE-YM9EC model.
Photo 4-2
Swing
Coated clamp
59
PHOTOS
Earth cable
Control box
Side panel
Screw
Bracket
(R)